Product #1W - epoxy coating for walls, is a two component, 100% solids epoxy Hi-Build epoxy wall coating used for high indoor traffic areas where abrasion resistance is required; for protection against mild corrosion; and as a decorative waterproof coating for walls, tanks, etc.
Surfaces to receive Epoxy.com Product #1W Epoxy Wall Coating must be clean and sound. Remove all dirt, laitance, grease curing compounds and other foreign matter by sandblasting, mechanical abrasion, or acid etching. Remove water and dust from all surfaces with an oil-free blast immediately prior to application.
Temperature of Product #1W Epoxy Wall Coating must be 50 degrees F or above at time of mixing. Stir each component separately before blending. Mix 4 parts by volume of Part A with 1 part by volume of Part B for three minutes with a low speed electric drill motor equipped with a mixing paddle.
Apply Product #1W Epoxy Wall Coating with a roller, brush, or spray equipment. Two coats are recommended. Thickness per coat should be 7-10 mils. Seven days cure time is required to reach maximum chemical resistance.
DO NOT apply at temperatures below 40° F. Surface must be dry.
Prolonged or repeated exposure may cause eye and skin irritation. If contact occurs, wash immediately and seek medical help. Use safety glasses with side shields and wear protective rubber gloves.
All tools and equipment should be cleaned before the system gels. Use MEK, Acetone, or any lacquer solvent.
APPLICATION PROPERTIES @77° F |
|
Mix Ratio | 4:1 By Volume |
Viscosity (mixed) | 2000 -2500 CPS |
Pot Life (200 gr.) | 40-50 minutes |
Tack Free to Touch | 8 to 10 Hours |
Initial Cure | 24 Hours |
Final Cure | 7 Days |
Packaging Unit Size | 1.25 gal. unit, 5 gallon unit |
Standard Colors | White, Light Gray, Dark Gray, Taupe, Sand, Old Gold, Mocha, Brick Red, Slate Blue, Colonial Green, Deep Blue, Black, Safety Yellow |
Click
the picture of color card below for a larger version of this picture
of the color chart.
Pleasenote: The picture to the right is a photographic reproduction of the
color card for this product. The photo reproduction process and your
monitor and/or printer will change these colors. This chart is to give you
an idea of the colors available and not intended for critical color selections.
TENSILE PROPERTIES | |
---|---|
Tensile Strength (ASTM D-638) | 5500 psi. min. |
Elongation | 4-5% |